Fosroc Thioflex 600

Multi-component, gun and pouring grade, polysulphide sealant

Category:

Multi-component, gun and pouring grade, polysulphide sealant

Uses

Sealing movement joints in building and civil engineering structures, including superstructures, reservoirs, floors,basements and subways.

Advantages

  • A high quality product meeting key international standards
  • Forms a tough, elastic rubber-like seal
  • Acts as an acoustic sealant
  • Accommodates continuous and cyclic movement
  • Excellent adhesion to most common substrates
  • High resistance to ageing reduces physical damage due to climatic extremes

Standards compliance

  • British Standard BS 4254: 1983.
  • British Standard BS 6920: 1988 (gun grade grey).
  • U.S. Federal Specification TT-S-00227E November 1969 (amended 1970).
  • Water Byelaws Scheme – Approved Product.
  • DTp specification for Highway Works Dec 1991 series 1000 clause 1017.
  • ASTM C 920-87, Type M, Class 25.

Description

Thioflex 600 is a multi-component joint sealant, based on a liquid polysulphide polymer, which when mixed and applied,cures to form a tough, rubber-like seal. The cured seal-ant exhibits excellent adhesion to most surfaces including primed concrete, glass, aluminium and stainless steel.

Thioflex 600 is available in gun and pouring grades. The gun grade is ideal for general application. It is packed in ready to mix, 2.5 litre & 4 litre tins containing the base and curing agent in the correct proportions. The pouring grade for joints in horizontal surfaces is supplied in 4 litre & 5 litre packs with the base and curing agent in separate tins. Both these grades are available in Grey colour only.

For coloured sealants, Fosroc recommends the use of Ni-to seal MS300* ‡ , a single component high performance silyl terminated polyether sealant, available in white, grey, black, portland, rustic red and brown.

Thioflex 600 is particularly recommended for use in high rise buildings and other applications where access for subsequent maintenance will be difficult and the risk of early movement failure must be minimised. It is also suitable for sealing joints in brickwork, retaining walls, reservoirs, basement sand subways. Thioflex 600 pouring grade is recommended for sealing expansion joints and stress relief joints in floors or other horizontal surfaces.

Specification

Joints shall be sealed using Fosroc Thioflex 600, two part, polysulphide sealant, manufactured by Fosroc to BS 42541983, and ASTM C 920 -87. Joints shall be prepared and the sealant mixed and applied in accordance with the manufacturer’s current data sheet.

Design criteria

Thioflex 600 may be applied to joints between 5 and 50 mm wide. Joints which are expected to experience cyclic movements should be designed to an optimum width:depth ratio of 2:1, subject to the overriding recommended minimum sealant depths set out below:

5 mm for metals, glass and other non-porous surfaces;

10 mm for all porous surfaces;

20 mm for trafficked joints and those subject to hydrostatic pressures.

To ensure that the sealant remains within its stated movement capacity (25% MAF), sealing slot widths should be designed in accordance with the recommendations of BS 6093.

The use of a surface primer is always required on porous surfaces. On non-porous surfaces a primer is not normally required except where glass or glazed surfaces are to be permanently immersed in water.