Solvent free, high build , epoxy resin floor coating
Uses
Nitoflor FC150 provides a hard wearing, chemical and abrasion resistant floor finish. It is ideally suited for use in wet areas where a high degree of resistance to chemicals, oil sand grease is required such as :
- Dairies
- Soft drinks production facilities
- Chemical manufacturing plants
- Car parks and workshops
Advantages
- Durable, low maintenance costs.
- Proven against a wide range of industrial chemicals.
- Solvent free – no odour during application.
- Slip resistant – different textures available to suit conditions to avoid slipping.
- Liquid applied providing complete protection.
- Available in a wide range of colours to improve the working environment and identify slip hazard areas.
- Specially formulated for use in Middle East conditions.
Description
Nitoflor FC150 is a solvent free system based on epoxy resins and curing agents specially selected for their ability to withstand chemical attack. The system consists of pre-weighed base & hardener components and a Nitoflor colour pack, all of which contain reactive elements that are essential to the installation of the system.
A slip resistant texture can be provided by the use of one of a range of Nitoflor Antislip Grains which have been carefully graded to ensure an even texture.
Specification
The epoxy resin floor coating shall be Nitoflor FC150 from Fosroc. The total dry film thickness of the coating shall be a minimum of 400 microns and shall have a compressive strength of 70 N/mm 2 , flexural strength of 40 N/mm 2 and a tensile strength of 20 N/mm 2 . The floor shall be prepared and the coating mixed and applied in accordance with the manufacturer’s current data sheet.
Design criteria
Nitoflor FC150 is applied as a floor coating system comprising of two top coats (depending on the substrate conditions a primer might be required), each top coat to be a minimum of 200 microns thick. To provide a slip resistant texture, the first top coat can be dressed with Nitoflor Antislip Grains*.
Typical Properties
The following values were obtained when tested at 20°C and 30°C.
